Additional Information
Method of application of dry decals.
Before painting the model, it is desirable to ground or at least degrease, otherwise the decal can tear off the paint from it when removing the film (this is especially important when using nitrokrasok).
1. Remove the protective paper. Cut a piece of decal from the sheet that you are going to convert to the model.
2. After that, with a hard object with a rounded end (for example, a soft pencil), often shade the right place on the front side of the decal. You should start with a small force, gradually increasing it. As the decal detaches from the film, it pales (a layer of air appears).
3. When a significant part of the image is translated, carefully lift the edge of the decal (but not all!), holding the rest with your finger. If the image is transferred entirely, then remove the film. If part of the image is not detached from the film, then return the film in place and shade this part again.
4. To permanently secure the image, apply protective paper and press it with your finger.
5. Final result.
